Use this to install a 1.5 inch TC port on your kettle. Drill a hole and install using a 1" NPS nut with a Dash 217 o-ring (not included). Use a 1.5 half TC gasket (included) for the outside to seal the adapter to the kettle wall. Then attach any 1.5 inch TC hardware you like using a 1.5 inch Tri Clamp. Will require a 1 and 3/8 inch hole to install into.
All stainless steel construction
Note: Electric heating elements will not fit through these bulkheads, the inside diameter is a little too narrow.
For heating element installs use our weldless bulkheads for heating elements.